Heat Exchanger, Heat Recovery Though The Wastewater (Option); Power Connection - Wexiodisk WD-6 Installation And User Manual

Installation

3.5.4 Heat exchanger, heat recovery though the wastewater (option)

3.5.5 Power connection

C=Heat exchanger
A WD-6 equipped with heat recovery through the wastewater cannot be connect-
ed to a WD-PRM 6.
This symbol on a component is a warning of electrical equipment. The component
may only be removed by a qualified electrician. The machine is sensitive to elec-
trostatic discharge (ESD), which is why a static electricity wristband must be used
when handling the electronics.
Information about electrical connections can be found on the machine's wiring di-
agrams. These are located on the inside of the front panel. Store the diagrams in
the electrical cabinet after installation.
The machine must be connected to a lockable mains switch. This should be
placed on a wall, well-protected from water and from the steam which escapes
when the hood is opened.
The machine is supplied with the electrical cable connected (1).
WD-6
17
Rev. 4,0 (201302)