Wexiodisk WD-6 Installation And User Manual page 42

Instructions for use
Changing the water
For the best washing results, it is important to change the water often. For nor-
mally soiled loads, the washing water should be changed after around 50 washes.
Always change the water in the event of foam problems in the tank.
If IF09 appears on the display, this indicates that the water should be changed.
When the machine is in P0 mode with the hood open and the symbol (3) is lit,
change the water as follows:
Machines without a drain pump
•
•
•
•
•
•
•
Machines with a drain pump
•
•
•
•
•
•
•
•
•
WD-6
Check that the machine is in P0 mode.
Open the hood.
Remove the tank filters (12).
Empty the machine by turning the level pipe (13) anticlockwise.
When the tank is empty, turn the level pipe (13) clockwise and refit the tank
filters (12).
Check that the final rinse symbol (3) is lit.
Close the hood and the machine will refill.
Check that the machine is in P0 mode.
Open the hood.
Remove the tank filters (12) and the level pipe (13).
Press the 0/1 button (9).
Press P1 (6) to start the drain pump. "dP" appears on the display (2).
When the tank is empty, refit the level pipe (13) and the tank filters (12).
Press the 0/1 button (9).
Check that the final rinse symbol (3) is lit.
Close the hood and the machine will refill.
38
Rev. 4,0 (201302)