Hasler IM-460 User Manual page 38

Using the Feeder
The procedure below describes how to place a stack of mail pieces at the mail path
entrance.
Depending on the weighing method you will choose to run mail, you may have to
insert the envelopes one by one or to put a stack of envelopes on the hopper.
Each stack may mix envelopes of different thickness and size.
3
You may set envelopes to portrait feed.
How to Use the Feeder
How to Use the
Feeder
32
Taking a stack of mail pieces:
1
Arrange the mail pieces according to their size (the largest/
heaviest letters beneath).
2
Fan the envelopes to separate them.
3
Bevel the edge of the stack.
4
Place the envelopes on
the hopper, their upper
edge resting against the
rear guide.
Ensure that all the en-
velopes are
along the rear guide,
from largest to smallest.
5
Adjust the side guide for
large envelopes.
adjust the guide, push it
gently to rest against the
envelopes,
pressing.
Flap envelopes: close each flap separately (nested flaps are not
supported).
stacked
To
without