Filling and Adjusting the Feeder Sealer
10.2 Filling and Adjusting the Feeder
Filling the Sealer Bottle
The automatic feeder uses water for sealing envelopes.
If the system is out of water, the mailing process continues but the envelopes are not
sealed properly.
How to Fill the Sealer Bottle
How to Fill the
Sealer Bottle
10
Adjusting the Sealing Water Flow
Before you adjust the sealing water flow, make sure that the brushes and sponge are
clean (see How to Clean the Brushes and Sponge (Sealer) p.194).
How to Adjust the Sealing Water Flow
How to Adjust
the Sealing
Water Flow
192
Sealer
To add water to the bottle:
1
Remove the bottle from
its base and turn it over.
2
Unscrew the cap and fill
the bottle with water up
to the limit marks.
3
Screw the cap back and
put the bottle back into
place.
To adjust the sealing water flow:
1
Set the water flow using
the back lever.
When standing in front of
the Mixed-Size Feeder:
Push
towards the left-hand
side to increase the
water level.
Push
towards the right-hand side to decrease the water level.
the
lever
the
lever