Ink Cartridge Cover, Front Cover, Wireless Lan Pcb And Media Module Cover - Brother MFC-J6510DW Service Manual

3.9.9 Ink Cartridge Cover, Front Cover, Wireless LAN PCB and Media Module
Cover
(1) Open the ink cartridge cover fully, warp its center upward as shown below to release the
left end from the boss on the lower cover, and then remove the ink cartridge cover.
(2) Disconnect the wireless LAN PCB harness from the main PCB.
(3) Slightly pull the top of the front cover towards you and lift it up and off the lower cover
together with the wireless LAN PCB.
(4) Unlatch the media module cover from the lower cover and pull it out to the front.
Wireless LAN PCB
harness
Lower cover
LT cover
(For models with paper tray #2)
Assembling Notes:
• When mounting the ink cartridge cover, first insert the cover arm into the slit provided in the
right side of the lower cover and fit the right hole in the ink cartridge cover over the right
boss on the lower cover. Then warp the center of the ink cartridge cover upward as shown
above and fit the left hole over the left boss.
• When mounting the front cover, route the wireless LAN PCB harness through the upper
opening provided in the lower cover, fit the two hooks into the lower openings, and set the
front cover into place while lifting it up slightly.
Openings
Hooks
Slit
Boss
Lock arm
Media module cover
Front cover
3-91
Boss
Lock arm
Cover arm
Ink cartridge cover
(3_057)
Confidential