Assembling Notes:
• After mounting the scanner cover sensor actuator, check that the actuator springs back if
pressed with a finger.
• When mounting the control panel PCB ASSY, first fit it below the four tabs on the control
panel base and then secure it with the four latches (see the previous page). Make sure that the
cable linking the two PCBs is threaded through the cable guide as shown below.
Control panel PCB ASSY
Grounding wire
Viewed from the bottom
Cable guide
Touch panel harness
LCD flat cable
3-85
Control panel base
Panel-main harness
(3_052)
Confidential