6.1.8 Ink Cartridge Cover, Media Module Cover, Front cover, and WLAN PCB
(1) Open the ink cartridge cover fully, warp its center upward as shown below to release the
left boss from the lower cover, and then remove the ink cartridge cover.
(2) Unlatch the media module cover from the lower cover and pull it out to the front.
(3) Disconnect the WLAN PCB harness from the main PCB.
(4) Lightly pull up the retainers on the inside of the front cover to release them from the lower
cover. Then lightly lift up the front end of the lower cover and remove the front cover
together with the WLAN PCB.
WLAN PCB harness
Lower cover
Front cover
Retainers
Ink cartridge cover
Media module cover
Latch
6-43
Slit
Latch
Cover arm
Boss
Boss
(6_37)
Confidential