Brother MFC-J6510DW Service Manual page 235

Assembling Notes:
• When binding ink supply tubes with two tube clamps, align four ink supply tubes in the order
of Magenta, Cyan, Yellow, and Black from bottom to up, as shown on the previous page.
Fit tube clamp (1) (right-side one viewed from the front) over the magenta ink tube and bind
the cyan and yellow ones with the tube clamp and then fit tube clamp (2) (left-side one) over
the black ink tube and bind the yellow and cyan ones with the tube clamp so that those tube
clamps come to the recess of the tube support plate shown on the previous page.
• After mounting the ink refill ASSY, route all of the four ink supply tubes through the tube
guides on the tube support plate, aligning the four colors in the order shown on the previous
page, without overlapping each other. Next, put the sponge into place and pass the ink supply
tubes through the bent section of the tube support wire.
• When securing the head joint to the head/carriage unit with the joint leaf spring, route all of
the four ink supply tubes in front of the guide boss as shown above.
Guide boss
Head/carriage unit
Ink supply tubes
Head joint rubber
Upper cover
Head flat cables
Joint leaf spring
Head joint
Joint leaf spring
PF encoder disk
3-110
Head/carriage unit
(3_009b)
Confidential