Brother MFC-J6510DW Service Manual page 227

(6) For 100 V series As shown below, unlatch the power cord bush and pull it up from the AC
cord holder. Then release the power cord from the cable guides provided on the AC cord
holder (shown on
For 200 V series Remove screw "j" to release the grounding wire.
(7) Release the power supply shield from three locks "z" on the lower MJ/PS shield and pull it
up.
(8) Press the latch on the PS PCB insulator and pull out the insulator towards you, while
removing the power cord from the insulator.
(9) Remove three screws "h" from the power supply PCB.
(10) For 100 V series Remove screws "e" and "i" and detach the AC cord holder from the
lower MJ/PS shield.
For 200 V series Remove two screws "e" that secure the power inlet bracket and take the
bracket out together with the power inlet. Release the power cord from the cable guides.
Note: If the EXT cap has not been removed, remove it beforehand.
(11) Remove two screws "f" and detach the MJ shield from the lower MJ/PS shield.
(12) Disconnect the main-MJ (LINE) harness and main-MJ (EXT) harness from the MJ PCB
and release them from the cable guides on the MJ PCB insulator.
(13) Remove screw "g" and detach the MJ PCB and MJ PCB insulator from the lower MJ/PS
shield.
Grounding wire
Power inlet bracket
Power inlet
AC cord holder
200 V series
Power cord
Power supply shield
page 3-104).
Latch
"i"
MJ shield
MJ PCB
"j"
"e"
"e"
Power cord
MJ shield
bush
"e"
Earth frame
"f"
"f"
"f"
"g"
CN1
CN2
Lock "z"
"h"
"h"
"h"
Latch
PS PCB insulator
3-102
AC cord holder
MJ (EXT) harness (black)
MJ (LINE) harness (yellow)
MJ PCB insulator
Cable Lock "z"
guides
Lock "z"
Square opening
Lower MJ/PS frame
Lock "x"
(3_067)
Power supply PCB
"e" and "f": Screw, bind M3x4
"g" and "h": Taptite, cup S M3x6
"i": Screw, bind M4x6
"j": Screw pan (washer) M4x8DB
Confidential