Brother MFC-J6510DW Service Manual page 282

(9) To adjust the right margin in 1,200 dpi, enter the measured value (in units of 0.1 mm)
multiplied by 10.
In this example, the right margin measured in step (2) is 1.2 mm, so press the 1, 2, and OK
keys.
Upon completion of the entry, the machine automatically returns to the initial stage of the
maintenance mode.
(10) Go back to step (1) and print out the margin check pattern again.
(11) Measure the left and right margins on the printed pattern.
If both the left and right margins are within the range from 0.9 to 1.1 mm, the adjustment is
completed.
Bottom margin adjustment
(1) Measure the bottom margin on the "MEDIA CHECK" pattern printed in the left and right
margin adjustment procedure, step (1) above.
(Example) Bottom margin: 3.2 mm
If it is within the range from 2.9 to 3.1 mm, no adjustment is required. If not, go to step (2).
(2) If the bottom margin is out of the specified range, press the 6 key twice on the machine.
(3) Press the Black Start (Mono Start) key.
The "MEDIA SENSOR ADJ" appears on the LCD.
(4) Press the # key to display "BOTTOM :30."
(5) To adjust the bottom margin, enter the measured value (in units of 0.1 mm) multiplied by
10.
In this example, the bottom margin measured in step (1) is 3.2 mm, so press the 3, 2, and
OK keys.
Upon completion of the entry, the machine automatically returns to the initial stage of the
maintenance mode.
(6) Go back to step (1) of the left and right margin adjustment and print out the margin check
pattern again.
(7) Measure the bottom margin on the printed pattern.
If it is within the range from 2.9 to 3.1 mm, the adjustment is completed.
Note: To reset the correction values newly entered in the above procedure, press the 6, 6, Start,
8, 9, 5 and 4 keys in this order in the initial stage of the maintenance mode. The machine shows
"PARAMETER INIT" on the LCD and returns to the initial stage of the maintenance mode.
4-22 Confidential