Brother MFC-J6510DW Service Manual page 311

Error code The following error has occurred.
01 Failed to detect the external frame.
02 Internal image inclined.
03 Failed to detect position.
04 Failed to write head calibration data.
05 The uneven printing correction
function for upper and lower ends of
the nozzle is disabled with Function
code 88.
06 Cannot get memory space.
07 The scanner cover (scanner unit) is
open.
08 The ADF cover is open.
09 Other scanning errors
10 A media is inserted and also the USB
cable or LAN cable is connected.
• Clean the scanner glass.
• Reposition a document along the
document guides on the document
cover.
• Go back to step (1) and print out "Print
pattern for creating head calibration
data" again.
• Clean the scanner glass.
• Reposition a document along the
document guides on the document
cover.
• Restart the machine and perform the
function again.
• Replace the main PCB.
• Use Function code 88 (in
5.1.4.33 "Assurance Mode Switch
Setting (Function code 88) (User-
accessible)") to set selector 1 on AMS05
to "0."
• Delete stored data including fax data.
• Stop any other function if being used.
• Replace the main PCB.
• Close the scanner cover.
• Reconnect the panel-main harness.
• Reposition the scanner cover sensor
actuator.
• Replace the rubber keypad(s).
• Replace the control panel PCB.
• Replace the scanner cover.
• Replace the main PCB.
• Close the ADF cover.
• Reconnect the ADF cover switch
harness.
• Replace the ADF cover.
• Replace the ADF harness unit.
• Replace the main PCB.
• Use Function code 55
"Acquisition of White Level Data and
CIS Scanner Area Setting (Function
code 55)").
• Disconnect the USB cable.
5-7
Do the following:
Section
(Section 5.1.4.15
Confidential