Fine Adjustment Of Scanning Position (Function Code 54) - Brother MFC-J6510DW Service Manual

5.1.4.14 Fine Adjustment of Scanning Position (Function code 54)

Function
This function allows you to adjust the scanning position.
Operating Procedure
(1) Press the 5 and 4 keys in this order in the initial stage of the maintenance mode.
Simplex scanning models
The "SCAN ADJ SELECT" appears on the LCD.
Duplex scanning models
The "0:FRONT 1:BACK" appears on the LCD.
To adjust the top-face scanning position, press the 0 key; to adjust the bottom-face one,
press the 1 key.
The "SCAN ADJ SELECT" appears on the LCD.
(2) To adjust horizontal scanning (right and left edges), press the 0 key.
The "RL EDGE *" appears on the LCD.
To adjust vertical scanning (top edge), press the 1 key.
The "TOP EDGE *" appears on the LCD.
To adjust vertical scanning (bottom edge), press the 2 key.
The "BOTM EDGE *" appears on the LCD.
An asterisk (*) in the above messages denotes the current scanning position correction
value.
NOTE: Pressing a key except 0 to 2 keys sounds a rejection beep.
(3) Enter the correction value (in units of 0.1 mm) multiplied by 10.
To increase the value by 10 (1.0 mm), press the
increase the value by 1 (0.1 mm), press the
NOTE: Pressing the Clear key cancels the newly entered value.
NOTE: Pressing the Stop/Exit key returns the machine to the initial stage of the
maintenance mode without making changes of the correction value.
(4) Press the OK key (PHOTO CAPTURE key for models without OK key).
The machine displays the "ACCEPTED" on the LCD and returns to the initial stage of the
maintenance mode.
key; to decrease it, press the
key; to decrease it, press the
5-28
key. To
key.
Confidential