Brother MFC-J6510DW Service Manual page 48

Code 1 Code 2
A0 03
A0 11
A0 12
A0 13
A0 14
A0 15
A0 16
A0 17
A0 19
A8 01
A9 01
AA 18
B0 02
B0 03
B0 04
BF 01
BF 02
BF 03
*1 Available in German models only.
*2 Establishment of FAX communication
FAX communication is established when the calling station receives a DIS (reception capability) signal
from the called station and the called station receives an NSS or DCS (communications test) signal from
the calling station.
Error correction sequence not terminated even at the
final transmission speed for fallback.
Receive buffer empty. (5-second time-out)
Receive buffer full during operation except receiving
into memory.
Decoding error continued on 500 lines.
Decoding error continued for 10 seconds.
Time-out: 13 seconds or more for one-line
transmission.
RTC not found and carrier OFF signal detected for 6
seconds.
RTC found but no command detected for 60 seconds.
Receive buffer full during receiving into memory.
RTN, PIN, or ERR received at the calling terminal.
RTN, PIN, or ERR received at the called terminal.
Receive buffer full during receiving into memory.
Unable to receive the next-page data.
Unable to receive polling even during turn-around
transmission due to call reservation.
PC interface error.
Communication canceled by pressing the STOP key
before establishment of FAX communication
Communication canceled by pressing the STOP key
after establishment of FAX communication
Transmission canceled due to a scanning error caused
by no document or document feed problem in ADF
scanning in real time transmission.
2-18
Cause
*2
*2
.
Refer to:
Section 2.4.9.7
*1
*1
.
Confidential