Brother MFC-J6510DW Service Manual page 228

Assembling Notes:
• Before mounting the MJ shield, route the main-MJ harnesses (LINE and EXT) through the
cable guides on the MJ PCB insulator as shown on the next page.
• When setting the PS PCB insulator back into place, first pass the power cord through the
insulator, fit the rear end into the square opening provided in the lower MJ/PS shield and set
the latch into place. Thread the power cord through the cable guides on the PS PCB insulator
and AC cord holder.
Main-MJ (LINE) harness
(yellow)
Main-MJ (EXT) harness
(black)
Main-MJ (LINE) harness
(yellow)
Main-MJ (EXT) harness
(black)
Cable guide on the
MJ PCB insulator
Power supply PCB
PS PCB insulator
Square opening
AC cord holder
Power cord
Lock "z"
Cable guide on the
MJ PCB insulator
3-103
Power supply PCB
Square
opening
Latch
Routing the power cord
through the PS PCB insulator
and AC cord holder
Power supply shield
Power supply harness
PS PCB
insulator
Lower MJ/PS
shield
(3_068)
Power supply harness
Lock "z"
Power harness
holder
Lock "z"
Lower MJ/PS
shield
(3_069)
Confidential