Operator Call - Panasonic KX-T336 Manual

8.00 Operator Call
Description
Allows the extension users to call the
operaior by
dialing the feature number for ' Operator Call
(General)" or "Operator Call (Specific)."
Operation
Calling an operator
Up to two operators are assignable for the whole
system. If Tenant Service is available, two
operators are assignable for each tenant, that
makes four operators available for the whole
system.
If two operators are assigned in the system, or in
a tenant (if tenant Service is employed),
extension users can specify the operator (in the
same tenant) by dialing the feature number for
"Operator Call (Specific)."
Programming
Operator Call iSpecific)
I
I
I
Conditions
When calling an operator by dialing the feature
number for "Operator Call (General)," the
operator is selected according to the type of the
operator' s stations as shown below:
EXT
ATT
Ex-r
-
Operator 1 on?
Operator 1 or,?j
I
I
EXT
-
Operator 1 on,y
1. Lift the handset.
2. Calling an operator without
specifying
1) Dial the feature number for
"Operator Call (General)."
Calling an operator by specifying
1) Dial the feature number for
"Operator Call (Specific)."
2) Dial "1" to specify operator 1.
Dial "2" to specify operator 2.
When no operators are assigned, a user hears
reorder tone during executing Operator Call.
For the assignment of operators, refer to Section
3-B-5.00 "Operator."
5-A-l 7