Table of Contents
Advertisement
COMPRESSION PRESSURE CHECK
The compression pressure reading of a cylinder is a good indicator of its internal condition.
The decision to overhaul the cylinder is often based on the results of a compression test. Periodic mainte-
nance records kept at your dealership should include compression readings for each maintenance service.
COMPRESSION PRESSURE SPECIFICATION
Standard
1 100 – 1 500 kPa
(11 – 15 kgf/cm
Low compression pressure can indicate any of the following conditions:
* Excessively worn cylinder wall
* Worn piston or piston ring
* Piston ring stuck in groove
* Poor valve seating
* Ruptured or otherwise defective cylinder head gasket
Overhaul the engine in the following cases:
* Compression pressure in one of the cylinders is 900 kPa (9 kgf/cm
* The difference in compression pressure between any two cylinders is 200 kPa (2 kgf/cm
* All compression pressure readings are below 1 100 kPa (11 kgf/cm
kgf/cm
2
) and more.
COMPRESSION TEST PROCEDURE
NOTE:
* Before testing the engine for compression pressure, make
sure that the cylinder head nuts are tightened to the specified
torque values and the valves are properly adjusted.
* Have the engine warmed up before testing.
* Make sure that the battery is fully-charged.
Remove the related parts and test the compression pressure in
the following manner.
• Lift and support the fuel tank. (5-3)
• Remove all the spark plugs. (2-5)
• Install the compression gauge and adaptor in the spark plug
hole. Make sure that the connection is tight.
• Keep the throttle grip in the fully opened position.
• Press the starter button and crank the engine for a few sec-
onds. Record the maximum gauge reading as the cylinder
compression.
• Repeat this procedure with the other cylinders.
09915-64512: Compression gauge set
09913-10750: Adaptor
2
)
Limit
900 kPa
(9 kgf/cm
2
)
2
) and less.
2
) even when they measure 900 kPa (9
PERIODIC MAINTENANCE
Difference
200 kPa
(2 kgf/cm
2
)
2
) and more.
2-31
Hide quick links:
Advertisement
Chapters
Table of Contents
