Suzuki GSR600 Service Manual page 136

3-84 ENGINE
STARTER CLUTCH
• Install the washer 1.
• Install the starter clutch assembly onto the crankshaft.
NOTE:
When installing the starter clutch assembly, align the wide spline
teeth A and B .
• Install the starter clutch bolt with the washer.
• Hold the starter clutch with the special tool and tighten its bolt
to the specified torque.
 09920-34830: Starter clutch holder
 Starter clutch bolt: 54 N·m (5.4 kgf-m)
STARTER IDLE GEAR
• Install the starter idle gear No.2 1, its shaft 2 and concaved
washer 3.
• Apply SUZUKI BOND lightly to the mating surfaces A at the
parting line between the upper and middle crankcases and
surface B as shown.
 99000-31140: SUZUKI BOND "1207B"
• Install new gasket 4 and dowel pins 5.

Use a new gasket to prevent oil leakage.