Suzuki GSR600 Service Manual page 129

OIL STRAINER
• Install the O-ring.
• Apply SUZUKI SUPER GREASE "A" to the O-ring.
 99000-25010: SUZUKI SUPER GREASE "A"

Use new O-ring to prevent oil leakage.
• Install the oil strainer 1 as shown and tighten the oil strainer
bolts to the specified torque.
 Oil strainer bolt: 10 N·m (1.0 kgf-m)
OIL PRESSURE REGULATOR
• Apply SUZUKI SUPER GREASE "A" to the O-rings.
• Press in the oil pipe 1 to the crankcase.
 99000-25010: SUZUKI SUPER GREASE "A"

Use new O-ring to prevent oil leakage.
• Apply SUZUKI SUPER GREASE "A" to the O-ring.
• Press in the pipe 2 to the oil pan.
• Install the oil pressure regulator case 3 and tighten the bolts
4 to the specified torque.
 Oil pressure regulator case bolt 4: 10 N·m (1.0 kgf-m)
OIL PRESSURE SWITCH
• Apply SUZUKI BOND to the thread part of oil pressure switch
and tighten oil pressure switch to the specified torque.
 99000-31140: SUZUKI BOND "1207B"
 Oil pressure switch: 14 N·m (1.4 kgf-m)
NOTE:
Be careful not to apply SUZUKI BOND to the hole of thread end.
(or equivalent grease)
(or equivalent grease)
ENGINE 3-77