Suzuki GSR600 Service Manual page 137

• Install the starter clutch cover and tighten its bolt as shown.
NOTE:
Fit a new gasket washer to the starter clutch cover bolt C as
shown.

Use new gasket washer to prevent oil leakage.
 Starter clutch cover bolt: 10 N·m (1.0 kgf-m)
• Install the starter idle gear No.1 shaft 6, thrust washer 7,
bearing 8, starter idle gear No.1 9, washer 0, and con-
caved washer A.
• Install the dowel pins B and new gasket C.

Use a new gasket to prevent oil leakage.
• Install the starter idle gear cover and tighten its bolts to the
specified torque.
 Starter idle gear cover bolt: 10 N·m (1.0 kgf-m)
NOTE:
Fit the gasket washer to the bolt D .
GEARSHIFT SYSTEM
• Install the gearshift cam stopper 1, its bolt 2, washer 3 and
return spring 4.
NOTE:
Apply a small quantity of THREAD LOCK to the gearshift cam
stopper bolt 2 and tighten it to the specified torque.
 99000-32050: THREAD LOCK "1342"
 Gearshift cam stopper bolt: 10 N·m (1.0 kgf-m)
ENGINE 3-85