Suzuki GSR600 Service Manual page 105

• Remove the oil seal 1.
• Remove the gearshift shaft bearing with the special tool.
 09921-20240: Bearing remover set (15 mm)
Installation
• Install the bearings with the special tool.
 09913-70210: Bearing installer set (1, 2 22)
NOTE:
The stamped mark side of the gearshift shaft bearing faces out-
side.
• Install the oil seal with the special tool.
 09913-70210: Bearing installer set (22)
• Apply SUZUKI SUPER GREASE "A" to the oil seal lip.
 99000-25010: SUZUKI SUPER GREASE "A"
• Install the gearshift cam 4 with the bearing 5.
NOTE:
The stamped mark side of the gearshift cam bearing faces out-
side.
(3 32)
(or equivalent grease)
ENGINE 3-53