Suzuki GSR600 Service Manual page 144

3-92 ENGINE
CYLINDER HEAD
• Fit the dowel pins 1 and new cylinder head gasket 2 to the
cylinder.

Use new gasket to prevent gas leakage.
• Place the cylinder head on the cylinder.
NOTE:
When installing the cylinder head, keep the cam chain taut.
• Tighten the cylinder head bolts (M10) in the following
four-step.
Step 1:
• Tighten the cylinder head bolts to the specified torque with a
torque wrench sequentially and diagonally.
Step 2:
• Loosen all the cylinder head bolts diagonally.
Step 3:
• Retighten the cylinder head bolts to the specified torque with
a torque wrench sequentially and diagonally.
Step 4:
• Tighten the cylinder head bolts to the specified angles diago-
nally with an angular torque gauge.
 Cylinder head bolt (M10): Step 1/Step 3: 31 N·m (3.1 kgf-m)
NOTE:
Apply engine oil to the washers and thread portion of the bolts
before installing the cylinder head bolts.
• Tighten the cylinder head bolts to the specified torque.
 Cylinder head bolt (M6): 10 N·m (1.0 kgf-m)
Cylinder head side face bolt: 14 N·m (1.4 kgf-m)
Final Step: 60°