Suzuki GSR600 Service Manual page 121

• Install the pistons and conrods into the cylinders from upside.
NOTE:
When installing the pistons, the indent C of each piston head
must be brought to the exhaust side.

Be careful not to damage the cylinder wall and piston
jet by the conrod.
• Check that ID code D on each conrod faces intake side.

Be sure to clean the conrod big end.
• Apply MOLYBDENUM OIL SOLUTION to the crank pin bear-
ings surface.
 MOLYBDENUM OIL SOLUTION
CRANKSHAFT
• Position the No.2 and No.3 conrod big ends on the same side,
and the No.1 and No.4 conrod big ends on the opposite side
of No.2 and No.3.
ENGINE 3-69