Suzuki GSR600 Service Manual page 112

3-60 ENGINE
• Remove the bearing caps and measure the width of the com-
pressed plastigauge using the envelope scale. This measure-
ment should be taken at the widest part of the compressed
plastigauge.
 Conrod big end oil clearance:
Standard: 0.032 – 0.056 mm
Service Limit: 0.080 mm
• If the oil clearance exceeds the service limit, select the speci-
fied bearings from the bearing selection table.
• Check the corresponding conrod I.D. code number ("1" or "2")
A.
• Check the corresponding crank pin O.D. code number ("1",
"2" or "3") B.
 Bearing selection table
Code
1
Conrod
I.D A
2
 Conrod I.D.
Code
1
2
Crank pin O.D. B
1 2
Green Black
Black Brown
I.D. specification
34.000 – 34.008 mm
34.008 – 34.016 mm
3
Brown
Yellow