The following entries are displayed on this screen
LLDP-MED Parameters Config
Fast Start Count:
Device Class:
16.4.2 Port Config
On this page you can configure all ports' LLDP-MED parameters.
Choose the menu LLDP→LLDP-MED→Port Config to load the following page.
The following entries are displayed on this screen
LLDP-MED Port Config
Select:
LLDP-MED Status:
Included TLVs:
:
When LLDP-MED fast start mechanism is activated, multiple
LLDP-MED frames will be transmitted (the number of frames
equals this parameter). The default value is 4.
LLDP-MED devices are comprised of two primary device types:
Network Connectivity Devices and Endpoint Devices. In turn,
Endpoint Devices are composed of three defined Classes: Class I,
Class II and Class III. Bridge is a Network Connectivity Device.
Figure 16-7 LLDP-MED Port Configuration
:
Select the desired port to configure.
Configure the port's LLDP-MED status:
•
Enable: Enable the port's LLDP-MED status, and the port's
Admin Status will be changed to Tx&Rx.
•
Disable: Disable the port's LLDP-MED status.
Select TLVs to be included in outgoing LLDPDU.
352