Operation:
4.3 System Tools
The System Tools function, allowing you to manage the configuration file of the switch, can be
implemented on Boot Config, Config Restore, Config Backup, Firmware Upgrade, License
Load, System Reboot and System Reset pages.
4.3.1 Boot Config
On this page you can configure the boot file and the configuration file of the switch. When the
switch is powered on, it will start up with the startup image. If the startup fails, the switch will try to
start up with the backup image. If this startup fails too, the switch will changes to bootutil state, in
which circumstance the switch's Web interface is unavailable and you can enter into the bootutil
menu of the switch through the console connection.
When the startup process is finished, the switch will read the startup-config file. If it fails, the switch
will try to read the backup-config file. If it fails too, the switch will be restored to factory settings.
Choose the menu System → System Tools → Boot Config to load the following page.
The following entries are displayed on this screen:
Boot Table
Select:
Unit:
Click the Edit button of the desired entry, and you can edit the
corresponding user information. After modifying the settings,
please click the Modify button to make the modification effective.
Access level and user status of the current user information can't
be modified.
Figure 4-10 Boot Config
Select the unit(s).
Displays the unit ID.
22