Static Multicast Config - TP-Link JetStream T2700G-28TQ User Manual

Routed Port:
Interface State Table

Interface:
IP Address:
Querier IP:
Querier State:
Other Querier
Expire Time:
Number Of Groups:

11.2.3 Static Multicast Config

On this page you can configure the static multicast table. The multicast groups configured here are
not learned by IGMP and are independent of dynamic multicast groups and multicast filter.
Multicast IP addresses range from 224.0.0.1 to 239.255.255.255. The range for receivers to join is
from 224.0.1.0 to 239.255.255.255.
Enter the routed port the desired entry must carry.
The interface for which data is to be displayed or configured.
The IP address of the selected interface.
The address of the IGMP querier on the IP subnet to which the
selected interface is attached.
Indicates whether the selected interface is in querier or
non-querier mode.
The time in seconds remaining before the other querier
present timer expires. If the local system is the querier, this will
be zero.
The current number of dynamic groups for the selected
interface.
233