Cluster; Cluster Summary - TP-Link JetStream T2700G-28TQ User Manual

NTDP Interval Time:
NTDP Hops:
NTDP Hop Delay:
NTDP Port Delay:
Port Config

Selected Port(s):
Unselected Port(s):
Note:
NTDP function is effective only when NTDP function is enabled globally and for the port.

17.3 Cluster

A commander switch can recognize and add the candidate switch to a cluster automatically based
on NDP and NTDP. You can manually add the candidate switch to a cluster. If the candidate switch
is successfully added to the cluster, it will get a private IP address assigned by the commander
switch. You can manage and configure the member switch via the commander switch.
The Cluster function can be implemented on Cluster Summary, Cluster Config, Member Config
and Cluster Topology pages.

17.3.1 Cluster Summary

On this page you can view the status of the current cluster.
Choose the menu Cluster→Cluster→Cluster Summary to load the following page.
For a candidate switch, the following page is displayed:

The following entries are displayed on this screen:
Global Config

Cluster:
Enter the interval to collect topology information.
Enter the hop count the switch topology collects.
Enter the time between the switch receiving NTDP request
packets and the switch forwarding NTDP request packets for the
first time.
Enter the time between the port forwarding NTDP request packets
and its adjacent port forwarding NTDP request packets over.
Select a port will enable NTDP function of the port.
Unselect a port will disable NTDP function of the port.
Figure17-9 Cluster Summary for Candidate Switch
Displays the cluster status (enabled or disabled) of the switch.
365