Multicast Filter; Profile Config - TP-Link JetStream T2700G-28TQ User Manual

Static Multicast IP Table

Multicast IP:
VLAN ID:
Forward Port:

9.4 Multicast Filter

When IGMP Snooping is enabled, you can specified the multicast IP-range the ports can join so as
to restrict users ordering multicast programs via configuring multicast filter rules.
When applying for a multicast group, the host will send IGMP report message. After receiving the
report message, the switch will firstly check the multicast filter rules configured for the receiving
port. If the port can be added to the multicast group, it will be added to the multicast address table;
if the port cannot be added to the multicast group, the switch will drop the IGMP report message.
In that way, the multicast streams will not be transmitted to this port, which allows you to control
hosts joining the multicast group.
The profile and binding relationship configurations are shared between this page and
Binding.

9.4.1 Profile Config

On this page you can configure an IGMP profile.
Choose the menu Multicast→Multicast Filter→Profile Config to load the following page.
The following entries are displayed on this screen:
Profile Creation

Profile ID:
Displays the multicast IP.
Displays the VLAN ID of the multicast group.
Displays the forward port of the multicast group.
Figure 9-11 Multicast Filter
Specify the Profile ID you want to create, and it should be a
number between 1 and 999.
138
11.2.5 Profile