Network - TP-Link JetStream T2700G-28TQ User Manual

Passive Default:

10.9.3 Network

You can configure networks contained by an area on this page. The interfaces, whose IP address
fall into the networks, will be imported to the associated area.
Choose the menu Routing→OSPF→Network to load the following page.
The following entries are displayed on this screen:
Network Config

Process ID:
IP Address:
Wildcard Mask:
Area ID:
Network Table

Process:
Select:
IP Address:
Wildcard Mask:
Configure the global passive mode settings for all OSPF
interfaces. Configuring this field will overwrite any present
interface level passive mode settings. OSPF does not form
adjacencies on passive interfaces, but does advertise
attached networks as stub networks. The default value is
'Disable'.
Figure 10-47 OSPF Network
Select the desired OSPF process for configuration.
The IP address of the network.
The wildcard mask of the network. Normal subnet mask is also
supported.
The 32 bit unsigned integer that uniquely identifies the area to
which a router interface connects. If you assign an Area ID
which does not exist, the area will be created with default
values. It can be in decimal format or dotted decimal format.
Select one OSPF Process to display its network list.
Select the desired item for configuration. It is multi-optional.
Displays the IP address of the network.
Displays the wildcard mask of the network.
196