Interface Config - TP-Link JetStream T2700G-28TQ User Manual

RIP Distance:
Auto Summary:
Default Metric:
Redistribute Static:
Redistribute OSPF:
Redistribute Static
Metric:
Redistribute OSPF
Metric:
Update Timer:
Timeout Timer:
Garbage Timer:
Network Enable

You could add the network to enable RIP protocol here, so the interface in the network would
enable RIP protocol.
RIP Network List

Display the network enabled in the list. You could choose to delete the network here.

10.8.2 Interface Config

On this page, you can configure advanced parameters for the RIP.
Choose the menu Routing→RIP→Interface Config to load the following page.
The following entries are displayed on this screen:
Interface Config

Select:
IP Address/Mask:
Set the RIP router distance.
If you select enable groups of adjacent routes will be
summarized into single entries, in order to reduce the total
number of entries The default is disable.
Set the default metric for the redistributed routes. The valid
values are (1 to 15).
Choose to distribute Static router entries to RIP, the default is
disable.
Choose to distribute OSPF router entries to RIP, the default is
disable.
Set the metric of redistributed Static routes. The valid values
are (0 to 15).
Redistribute OSPF Metric
OSPF routes. The valid values are (0 to 15).
he timer interval to generate a complete response to every
neighboring gateway.
Upon expiration of the timeout, the route is no longer valid and
set to unreachable.
Upon expiration of the garbage-collection timer, the route is
finally removed from the tables.
Figure 10-28 RIP Interface Config
Select the interface for which data is to be configured.
The interface IP address and subnet mask. It cannot be
changed here.
173
Set the metric of redistributed