Application Example For Rip - TP-Link JetStream T2700G-28TQ User Manual

Choose the menu Routing→RIP→RIP Database to load the following page.
The following entries are displayed on this screen:
RIP Route Table

Destination
Network:
Next Hop:
Metric:
Interface Name:
Timer(s):

10.8.4 Application Example for RIP

Network Requirements

IP addresses of Switch A's three interfaces are 1.1.1.1/24, 2.1.1.1/24, 3.1.1.1/24 respectively.

IP addresses of Switch B's three interfaces are 1.1.1.2/24, 10.1.1.1/24, 11.1.1.1/24
respectively.
RIP is required to be enabled in all interfaces of Switch A and B. Network shall be

interconnected between Switch A and B with the use of RIPv2.
Network Diagram

Configuration Procedure

Configure Switch A

Steps Operation
1 Enable RIP
2 Enable the network
segments
the interfaces are
located
Figure 10-29 RIP Database
The destination IP address and subnet mask.
The Next hop IP address.
The metric to reach the destination IP address.
The gateway interface name.
The time of the route entry. If the timeout timer reach, the route
entry metric will be set to infinity and the destination would be
unreachable.
Note
Required. On page Routing→ RIP→ Basic Config, enable RIP,
select RIPv2 as RIP version.
Required. On page Routing→ RIP→ Basic Config Network
where Enable part, add network segments 1.1.1.0, 2.1.1.0, 3.1.1.0, and
enable RIP in these network segments. These network segments
will be displayed in RIP Network List after they are successfully
added.
175