Vpn Config; Port Enable - TP-Link JetStream T2700G-28TQ User Manual

Table 7-3 Values of Ethernet frame protocol type in common use
This VLAN VPN function is implemented on the VPN Config, VLAN Mapping and Port Enable
pages.

7.7.1 VPN Config

This page allows you to enable the VPN function, adjust the global TPID for VLAN-VPN packets
and enable the VPN up-link port. When VPN mode is enabled, the switch will add a tag to the
received tagged packet basing on the VLAN mapping entries.
Choose the menu VLAN→VLAN VPN→VPN Config to load the following page.
The following entries are displayed on this screen:
Global Config

VPN Mode:
Global TPID:
VPN Up-link Ports

Unit:
VPN Up-link ports:
Note:
If VPN mode is enabled, please create VLAN Mapping entries on the VLAN Mapping function
page.

7.7.2 Port Enable

On this page, you can enable the port for the VLAN Mapping function. Only the port is enabled,
can the configured VLAN Mapping function take effect.
Protocol type Value
LACP 0x8809
802.1X 0x888E
Figure 7-12 VPN Global Config
Allows you to Enable/Disable the VLAN-VPN function.
Enter the global TPID (Tag protocol identifier).
Select the unit ID of the desired member in the stack.
Select the desired port as the VPN Up-link port.
89