Storm Control - TP-Link JetStream T2700G-28TQ User Manual

Note:
1. If you enable ingress rate limit feature for the storm control-enabled port, storm control feature
will be disabled for this port.
2. When egress rate limit feature is enabled for one or more ports, you are suggested to disable
the flow control on each port to ensure the switch works normally.

12.2.2 Storm Control

Storm Control function allows the switch to filter broadcast, multicast and UL frame in the network.
If the transmission rate of the three kind packets exceeds the set bandwidth, the packets will be
automatically discarded to avoid network broadcast storm.
Choose the menu QoS→Bandwidth Control→Storm Control to load the following page.
The following entries are displayed on this screen:
Storm Control Config

UNIT:
Select:
Port:
Broadcast Rate :
Multicast Rate :
Figure 12-11 Storm Control
Select the unit ID of the desired member in the stack.
Select the desired port for Storm Control configuration. It is
multi-optional.
Displays the port number of the switch.
Select the bandwidth for receiving broadcast packets on the port.
The packet traffic exceeding the bandwidth will be discarded.
Select Disable to disable the broadcast control function for the
port.
Select the bandwidth for receiving multicast packets on the port.
The packet traffic exceeding the bandwidth will be discarded.
Select Disable to disable the multicast control function for the port.
275