Vlan Config - TP-Link JetStream T2700G-28TQ User Manual

9.1.3 VLAN Config

Multicast groups established by IGMP Snooping are based on VLANs. On this page you can
configure different IGMP parameters for different VLANs.
Choose the menu Multicast→IGMP Snooping→VLAN Config to load the following page.
The following entries are displayed on this screen:
VLAN Config

VLAN ID:
Router Port Time:
Member Port Time:
Leave Time:
Router Ports:
UNIT:
VLAN Table

Select:
VLAN ID:
Figure 9-6 VLAN Config
Enter the VLAN ID to enable IGMP Snooping for the desired
VLAN.
Specify the aging time of the router port. Within this time, if the
switch doesn't receive IGMP query message from the router port,
it will consider this port is not a router port any more.
Specify the aging time of the member port. Within this time, if the
switch doesn't receive IGMP report message from the member
port, it will consider this port is not a member port any more.
Specify the interval between the switch receiving a leave
message from a host and the switch removing the host from the
multicast groups.
Enter the static router port which is mainly used in the network
with stable topology.
Select the unit ID of the desired member in the stack.
Select the desired VLAN ID for configuration. It is multi-optional.
Displays the VLAN ID.
129