Rp Info - TP-Link JetStream T2700G-28TQ User Manual

11.4.6 RP Info

Choose the menu Multicast Routing→PIM SM→RP Info to load the following page.
The following entries are displayed on this screen:
Search Option

Search Option:
RP Information

Group:
RP:
Configuration Procedure for PIM SM:
Step Operation
1 Configure interface.
2 Configure routing
protocol.
3 Enable multicast
routing and PIM SM.
4 Configure static RP
or configure
candidate BSR and
candidate RP.
5 Enable IGMP.
Figure 11-25 RP Info
ALL: Select All to display all entries.

Group: Select Group and enter the group IP address of

desired entry.
RP: Select RP and enter the RP IP address of desired

entry.
Displays the group address.
Displays the RP address.
Description
Required. Configure IP addresses and subnet masks of routing
interfaces on Routing→ Interface→Interface Config page.
Required. Configure the routing entries via static route or dynamic
routing protocol like OSPF, and make sure all the switches can
communicate with each other and update the routing information
through a unicast routing protocol dynamically.
Required. Enable multicast routing on Multicast Routing→Global
Config page. Enable PIM SM on routing interfaces on Multicast
Routing→PIM SM→PIM SM Interface page.
Required. Configure static RP or configure a specified routing
interface as candidate RP on Multicast Routing→PIM SM→RP
page. Configure a specified routing interface as candidate BSR on
Multicast Routing→PIM SM→BSR page.
Required. Enable IGMP on the routing interfaces which connect to the
receivers on Multicast Routing→IGMP→Interface Config page.
259