42
en | Configuring the Device
11
Configuring the Device
Before powering the High Speed Pan/Tilt, it must be properly configured. To configure the DIP
switches inside the configuration window, proceed as follows:
1.
2.
Figure 11.1: Positioning the DIP Switches
Reference
1
2
3
4
5
2013.11 | 5.2 | F.01U.291.981
Open the configuration window (as seen in , page 42) by unscrewing the screws with a
3 mm Allen wrench.
Verify that the position of the DIP switches are the same as in, page 42.
Description
Pelco D Baud Rate
Not Used, All Off
Address
RS485 Terminations
Biphase + Bilinx
Operation Manual
High-Speed Positioning System
(HSPS)
Bosch Security Systems, Inc.