Connections - Bosch UPH series Operation Manual

High-Speed Positioning System
(HSPS)
11.6

Connections

All versions support Bilinx and Biphase telemetry control, i.e.: PTZ.
The PTZ menu setup of UPH Series is done via the AUX ON - 200 - Enter. The camera menu
setup is done via two different AUX commands, i.e.: AUX ON - 46 - Enter (Dinion main menu)
and AUX ON - 801 - Enter (Dinion installation menu). See 9 Keyboard Commands List - Bosch
for more information about keyboard commands.
Bilinx is a Bosch two-way communication protocol that allows remote control, configuration,
and updates over a video coax cable. Bilinx is available on all UPH models.
Biphase is used for communicating telemetry (control) and set up information with the
UPH‑Series units over a shielded twisted pair. Biphase does not pass the video signal from the
UPH-Series units, so a separate video coax cable is required. Biphase should be wired with
Belden 8760 or equivalent. Biphase is available on all UPH models.
Note: If the UPH is the only Biphase unit connected, or the last unit in a daisy chain
configuration, then turn ON dip-switch 1 of Biphase + Bilinx to terminate the data line. Turn
OFF dip-switch 1 of Biphase + Bilinx for each UPH in a daisy chain (i.e. unterminated). A
maximum of four (4) UPH units can be daisy chained together.
Figure 11.2: Typical Setup via an Interface Box
1
2
3
4
Bosch Security Systems, Inc.
LTC 5136 or equivalent
RS-232
LTC 8786
Biphase
5 UPH Series: unitized pan/tilt head
6 Video out, coax
7 CCTV Monitor
Operation Manual
Configuring the Device | en
2013.11 | 5.2 | F.01U.291.981
45