Wiring The Video Cable - Bosch UPH series Operation Manual

High-Speed Positioning System
(HSPS)
Figure 5.5: Tie Threads used to Group and Secure Cables
5.3

Wiring the Video Cable

Note: The terminals support AWG 20 (0.5 mm
To wire the video cable, follow these steps:
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Locate the coaxial termination cable that is in the Cable and Screws accessory bag.
Use a small screwdriver to press down on the GND push latch (see the figure) and attach
the black ground wire to the GND terminal.
Use a small screwdriver to press down on the VIDEO push latch (see group 101) and
attach the clear coaxial conductor to the VIDEO terminal.
Retract the shield covering the female BNC connector and route the coaxial termination
cable into the base of the device.
Route the incoming coaxial cable with a male BNC connector into the base and connect
to the female BNC connector on the coaxial termination cable.
Move the shield to cover the coaxial connection.
Installing the High Speed Positioning System | en
) to AWG 28 (0.08 mm
2
Operation Manual
25
) cables.
2
2013.11 | 5.2 | F.01U.291.981