Table of Contents
Advertisement
24
en | Installing the High Speed Positioning System
5.2
Wiring the Device
Figure 5.4: Preparing the Cables for Wiring
1.
2.
3.
2013.11 | 5.2 | F.01U.291.981
Cut the cables to approximately 152.4 mm (6 in.) (see the figure Preparing the Cables for
Wiring, above). The earth cable must be longer than the power wires by approximately 10
mm or more to prevent disconnection.
Cover the power cable with the plastic tube supplied. Fix it with the tie thread.
Make a group with all signal cables and fix them with the tie thread. See the illustration
below for a proper cable connection.
Note: IR360 version boards will vary slightly because the signals connector has 16 lines as
instead of 19, as shown below.
Operation Manual
High-Speed Positioning System
(HSPS)
Bosch Security Systems, Inc.
Advertisement
Table of Contents
