Table of Contents
Advertisement
High-Speed Positioning System
(HSPS)
4.
5.
6.
7.
8.
Bosch Security Systems, Inc.
Connect the 4-pin alarm cable from the camera to the mating connector from the J27
location on the board.
Connect the "L" adapter end of the coax cable (supplied in the Cable and Screw
accessory bag) to the coax connector on the back of the camera. VIDEO IN connector
from the camera to the J1 location on the board.
Route the other end of the coax cable along the right side (looking from behind) of the
camera and under the camera tray. Then, connect the coax cable to the J1 location on the
board.
Wrap one of the 102 x 2.5 mm tie wraps around the zoom and focus cable and the coax
cable, near the location where the cables connect to the board.
Close and secure the housing lid.
Operation Manual
Installing the Camera/Lens | en
2013.11 | 5.2 | F.01U.291.981
19
Advertisement
Table of Contents
