Making Connections For The Pump Of The Washer Kit (Optional) - Bosch UPH series Operation Manual

High-Speed Positioning System
(HSPS)
10 Making Connections for the Pump of the Washer Kit
(Optional)
The Bosch Washer Kit (pump and water reservoir tank) is an optional product, available
separately from Bosch, that connects directly to the High Speed Positioning System in order
to clean dirt and debris that accumulates on the glass in front of the lens of the camera,
improving visibility through the camera.
The figure below identifies the O1 and C1 connections on terminal block J7 on the connector
board in the base of the device. All models have these connections to activate the pump
contact and start the washer pump (using maxinum 50 VDC/30 VAC, 1 A), even if not all
models will have a Washer Kit attached.
For specifics about the Washer Kit itself, see the Installation Manual of the Washer Kit.
Warning!
These connections should be made only by skilled installers who comply scrupulously with all
!
the wiring and power supply instructions. Failure to do so could create serious risks for the
operator and would invalidate the warranty.
Figure 10.1: Terminal block J7 on the connector board in the base
Bosch Security Systems, Inc.
Making Connections for the Pump of the Washer Kit (Optional) | en
Operation Manual
41
2013.11 | 5.2 | F.01U.291.981