Bosch UPH series Operation Manual page 22

22 en | Installing the High Speed Positioning System
2.
Figure 5.2: Optional Wall Mount (1) or Pole Mount (2)
Warning!
The cables should not be accessible by unauthorized personnel; cables should be secured to
!
fixed locations at appropriate intervals to bare the weight of the cables, for example, cables
running inside a tall camera pole.
Warning!
!
Be sure to use appropriately strong and load-bearing bolts and other fixing materials when
installing any UPH mountings to any surface.
3.
Part
MTC-PUPH
MTC-WUPH
MTC-POLE-W
MTC-CORN-W
Installing the optional washer kit
Notice!
If using a washer kit (optional, sold separately), you must install the support for the washer
pipe before positioning and wiring the pan/tilt. Refer to the Installation Manual for the Washer
Kit.
Installing the HSPS base on the mount
1.
2.
3.
2013.11 | 5.2 | F.01U.291.981
Insert the cables into the optional wall or pole mount so that they protrude approximately
0.5 m (19.7 in.).
1
Attach the optional wall or pole mount according to the specific mounting manual.
Description
Outdoor Pole Mount for UPH Series
Outdoor Wall Mount for UPH Series
Pole Adapter for MTC-WUPH
Corner Adapter for MTC-WUPH
Remove the desiccant bag from inside the base and discard.
Remove the cable glands from the base and fit the gasket / seal ring.
Insert the cables into the cable glands while holding the base approximately 20 cm from
the bracket. Note that there are three glands; one for power, one for video, and one for
data / IO cables.
Operation Manual
High-Speed Positioning System
(HSPS)
2
Bosch Security Systems, Inc.