Configuring The Device; Baud Rate Switches - Bosch UPH-2D Series Instruction Manual

High Speed Pan/Tilt System
7

Configuring the Device

Before powering the High Speed Pan/Tilt, it must be properly configured. To configure the DIP
switches inside the configuration window, proceed as follows:
1.
2.
Fig. 7.1 Positioning the DIP Switches
For all DIP switches, when the rocker is down the switch is OFF, or represents the logical
value "0"; when the rocker is up, the switch is ON, with logical value "1". The white rectangle
represents the position of the rocker.
7.1

Baud Rate Switches

DIP switches 4, 3, and 2 are not used; the unit has fixed baud rates. DIP switch No. 1 is used
to update the firmware: PROGRAM. ON and PROGRAM. OFF. During normal use, make sure
the rocker for DIP switch No. 1 is OFF (PROGRAM. OFF).
DIP-SWITCH 1
(for updating the firmware)
Table 7.1 Updating the Firmware
Bosch Security Systems
Open the configuration window by unscrewing the screws with a 3 mm Allen wrench. See
Figure 6.3 for the location of the configuration window.
Verify that the position of the DIP switches are the same as in Figure 7.1. Starting from
the left, we see the baud rate, protocol, and the peripheral address selectors, respec-
tively.
Baud
Rate
Terminations
Protocol
Rs485
Program ON
Instruction Manual
Configuring the Device | en
Address +
Serial
Biphase +
Bilinx
Program OFF
F01U.073.990 | Version 1.0 | 2007.07
25