Related Manuals for Bosch UHI-OG-0
Summary of Contents for Bosch UHI-OG-0
- Page 1 UHI/UHO Series UHI-OG-0 | UHI-OGS-0 | UHO-HGS-10 | UHO-HBGS-10 | UHO- HBPS-10 | UHO-HGS-50 | UHO-HBGS-50 | UHO-HPS-50 | UHO- HBPS-50 | UHO-HBGS-60 User Manual...
-
Page 3: Table Of Contents
Feed-through Wiring 4.7.4 Power Connections Video coax connection Lens wiring 4.10 Camera/Lens adjustment 4.11 Final assembly 4.12 Sunshield 4.13 Fuse replacement UHO-HBPS-10, -50, and UHO-HPS-50 Camera/lens wiring Video coax connection Bosch Security Systems User Manual docnumber | V 2.0 | 2007.01... - Page 4 4 en | UHI/UHO Series Operation Maintenance Exploded view docnumber | V 2.0 | 2007.01 User Manual Bosch Security Systems...
-
Page 5: Important Safety Instructions
Before proceeding, be sure to disconnect the power from the cable to be installed into the unit. – For battery powered units, refer to the operating instruc- tions. Bosch Security Systems User Manual docnumber | V 2.0 | 2007.01... - Page 6 15. Attachments, changes or modifications - Only use attachments/acces- sories specified by the manufacturer. Any change or modification not expressly approved by Bosch of the equipment or authorization agree- ment could void the user's guarantee or authority to operate the equip- ment.
- Page 7 SELV or Limited Power Source. For safety reasons the environmental specification of the camera lens assembly must be within the environmental specification of -10 °C (+14 °F) to +50 °C (+122 °F). Bosch Security Systems User Manual docnumber | V 2.0 | 2007.01...
- Page 8 Please dispose of these units at an environmentally compatible recycling facility, per European Directive 2002/96/EC. Environmental statement - Bosch has a strong commitment towards the environment. This unit has been designed to respect the environment as much as possible.
- Page 9 Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security Systems cannot be held liable for any damage that results from missing video information. To minimize the risk of lost digital informa- tion, Bosch Security Systems recommends multiple, redundant recording systems, and a procedure to back up all analog and digital information.
- Page 10 10 en | UHI/UHO Series docnumber | V 2.0 | 2007.01 User Manual Bosch Security Systems...
-
Page 11: Unpacking
If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any items are missing, notify your Bosch Security Systems, Inc. sales repre- sentative or customer service representative. The shipping car- ton is the safest container in which the unit may be transported. -
Page 12: Description
198 to 254 VAC / 45 W power Camera ratings 230 VAC Max camera/lens 91 x 81 x 262 mm (3.6 x 3.2 x 10.3 in) size (HWD) Table 3.4 Outdoor 230 volt units F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... -
Page 13: Installation
Weight without lens 450 g max Weight with lens 1 kg max Temperature under operating -20 °C to +50 °C (-4 °F to +122 °F) conditions Table 4.1 Specifications for cameras Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01... -
Page 14: Cable Requirements
UL/C.S.A., UL VW-1 Environmental Outdoor rated Temperature rating +105° C (+221° F) or greater Reference type Belden 19509, 3-conductor; Northwire FSJT183-81K, 3-conduc- Table 4.3 Power cord specifications for North America F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... -
Page 15: Lens Control Cable
The outermost set of 1/4-20 threaded holes are for mount- ing to feed-through mounts, and the innermost 1/4-20 holes are for mounting to all other mounts and pan/tilts. See Figure 4.1. Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01... -
Page 16: Opening The Cover
Camera/Lens installation Remove the two screws holding the camera tray to the housing. Remove tray from the housing. If using the feed-through feature, refer to Section 4.7.3 Feed-through Wiring. F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... - Page 17 Figure 4.5. Slide the entire assembly forward approximately 5 mm (0.2 in) from the front of the window. Install screws into the appropriate holes. Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01...
-
Page 18: Camera/Lens Wiring
4.0 mm (0.16 in) to 7.0 mm (0.28 in). The two larger 1/2-inch NPT fittings accept cables with diame- ters from 6.5 mm (0.26 in) to 10.5 mm (0.42 in). F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... -
Page 19: Conduit
Tighten the fitting to 4.0 Nm to 4.5 Nm (35 inch-lb to 40 inch-lb). This torque rating is approximately 1 to 1.5 turns past the point where the fitting starts to grip the Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01... -
Page 20: Power Connections
Connect the safety (earth) ground: A terminal lug is provided for connecting the external safety (earth) ground to the grounding post on the PCB bracket assembly. See Figure 4.7. F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... - Page 21 8.5 Nm to 9.0 Nm (75 inch-lb to 80 inch-lb). This torque rating is approximately one to one and a half turns past the point where the fitting starts to grip the wire. Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01...
- Page 22 8 mm (0.31 in) of insulation away from the wire. Be sure not to nick the wires. Connect these wires to the connec- tors provided on the terminal block. See Figure 4.8. F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems...
- Page 23 Power connection Green G (safety ground) Table 4.7 NOTE! Drawing layout and installation wiring diagram is in accordance with the NEC, ANSI/NFPA 70 for indicating recommended locations and wiring methods. Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01...
-
Page 24: Video Coax Connection
8.5 Nm to 9.0 Nm (75 inch-lb to 80 inch-lb). This torque rating is approximately one to one and a half turns past the point where the fitting starts to grip the wire. F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... -
Page 25: Lens Wiring
Replace the camera and bracket back into the housing. Slide the camera/lens tray into the slot near the clasp side of the housing. See Figure 4.3. Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01... -
Page 26: Sunshield
4 A, 250 VAC 120 VAC 2 A, 250 VAC 230 VAC 2 A, 250 VAC Table 4.8 Specifications for replacement fuses NOTE! There is a spare fuse inside the housing. F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... -
Page 27: Uho-Hbps-10, -50, And Uho-Hps-50
See Figure 5.1). Sealing gasket Cable nut 24 VAC ONLY! Male clamping ring Metal washer Internal strain relief 230 VAC ONLY! Female clamping ring Fig. 5.1 Mating connector 4-pin assembly Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01... -
Page 28: Video Coax Connection
These housings require no operational adjustments other than camera/lens adjustments. Maintenance No special maintenance is required other than occasional clean- ing the window. The window can be cleaned with water or any non-aggressive liquid. F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems... -
Page 29: Exploded View
UHI/UHO Series Exploded view | en Exploded view Fig. 8.1 Exploded view Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01... - Page 30 (FPF12) Front window holder (QG001) 11. Camera tray-zoom lens version, (SP001) Camera tray-type A (SP002) Feed-through base plate (DZFT1) 12. Accessory bag (not shown) (PJB01) Table 8.1 Parts list F.01U.026937 | V 2.0 | 2007.01 User Manual Bosch Security Systems...
- Page 32 Bosch Security Systems Robert-Koch-Straße 100 D-85521 Ottobrunn Germany Telefon 089 6290-0 089 6290-1020 www.boschsecuritysystems.com © Bosch Security Systems, 2007...