Table of Contents
Advertisement
High-Speed Positioning System
(HSPS)
Figure 5.1: Diagram of mount, washer support, base
1
2
3
4
5
6
7
8
Warning!
Take special care when attaching and fastening down the device.
Fixing dowel pins with a traction torque rating/load of at least 300 dN each are required:
- When the MTC-WUPH Wall Mount is fixed to a wall.
!
- If the mount is to be attached to a concrete surface.
For a metal surface, use screws/bolts with a diameter of at least 8 mm and of an appropriate
length. The clamping system must support at least four times the weight of the entire
equipment, including the pan and tilt head, lenses, and camera.
Installing the mount
To install the device, follow these steps:
1.
Bosch Security Systems, Inc.
Support for MTC-WUPH (wall mount) or MTC-PUPH (pole mount)
Cable glands
Support for the washer pipe for the optional washer kit
Base
Screws (4)
Washers (4)
Screw seals (4)
Gasket
Determine the location to install the device.
When selecting a location, a minimum clearance of 300 mm (12 in.) in front of the device
and 300 mm (12 in.) in back of the device is required to facilitate component removal and
installation.
The device should be installed vertically. Any other position could impair the performance
of the device.
Do not attach the device upside down.
Installing the High Speed Positioning System | en
Operation Manual
21
2013.11 | 5.2 | F.01U.291.981
Advertisement
Table of Contents
