Table of Contents
Advertisement
20
en | Installing the High Speed Positioning System
5
Installing the High Speed Positioning System
This chapter outlines the procedures needed to mount the High Speed Positioning System.
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any
damages or losses caused by incorrect or improper installation.
Notice!
The High-speed Positioning System device cannot be mounted upside down! This
configuration stresses bearings and mechanical components; no liabilities are accepted and
all warranties are void.
Notice!
In accordance with NEC laws, you may be required to install an external power junction box.
The following warnings apply to the device itself, the video cable, and the connections for
Biphase and for RS-422/Pelco D.
Warning!
!
The installation is type TNV-1. Do not connect it to SELV circuits.
Warning!
The installation is type CDS (Cable Distribution System). Do not connect it to SELV circuits.
!
In order to reduce the risk of fire, only use UL Listed or CSA certified telecommunication line
cord sizes greater than or equal to 26 AWG.
5.1
Mounting the High Speed Positioning System
The High Speed Positioning System can be mounted with either a wall mount (MTC-WUPH,
sold separately) or a pole mount (MTC-PUPH, sold separately).
The figure below illustrates the configuration of the mount, the support for the washer pipe
for the optional washer kit, and the base of the device.
2013.11 | 5.2 | F.01U.291.981
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
®
Operation Manual
High-Speed Positioning System
(HSPS)
Bosch Security Systems, Inc.
Advertisement
Table of Contents
