Table of Contents
Advertisement
Operator Panel
The following procedures cover removal and replacement of the operator panel.
Removal
1. If you have not already done so, shut down the system as described in "Stopping
the System" on page 248.
2. If you have not already done so, unplug the system power cables from the electrical
outlets.
3. Remove the bezel as described in "Bezels" on page 253.
4. Remove the operator panel by grasping the release levers and pulling the operator
panel tray from the system.
5. If installed, remove the cables from the disk drive.
6. Disconnect the cables from the operator panel and remove the operator panel.
Replacement
1. To replace, perform removal steps in reverse order.
2. Complete the VPD update procedure as described in "System Vital Product Data
(VPD) Update Procedure" on page 278.
Chapter 9. Removal and Replacement Procedures
277
Advertisement
Table of Contents
