Processor Card; Removal - IBM 265 Service Manual

Processor Card

The following procedures cover removal and replacement of the processor card.
Before performing these procedures, read "Handling Static-Sensitive Devices" on
page 248.

Removal

1. If you have not already done so, shut down the system as described in "Stopping
the System" on page 248.
2. If you have not already done so, unplug the system power cable from the electrical
outlet.
3. If you have not already done so, remove the service access cover as described in
"Service Access Cover" on page 251.
4. Remove the processor and memory card cover as described in "Processor and
Memory Card Cover" on page 254.
5. The processor card is secured in place with retention latches, one on each end of
the card. Open the retention latches.
Attention: To prevent damage to the card and the card connectors, open or close
6. Remove the card from the connector.
the retention latches at the same time.
Chapter 9. Removal and Replacement Procedures
263