Fan; Operator Information Panel - IBM IntelliStation E Pro Hardware Maintenance Manual

1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover (see"Removing the cover of the 6216" on page 45.
3. Rotate the retainer up and pull the adapter retainer away from the chassis.
To install the adapter retainer, reverse the previous steps, sliding the two side knobs
on the retainer into the channels provided for them on the chassis and positioning
the retainer so that the plastic tabs are pressed against the inside of the PCI slot
covers.

Fan

Note: Read "Before you begin" on page 41 and the safety notices at "Safety
Complete the following steps to remove the fan:
1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover and the frame-support bracket (see"Removing the cover of
3. Remove the air baffle (see "Baffle" on page 79).
4. Disconnect the fan cable from the system board.
5. Push the two of the four tabs on the right of the chassis toward the rear, and
6. Pull the fan up and out of the chassis.
To install the rear fan, reverse the previous steps.

Operator information panel

Note: Read "Before you begin" on page 41 and the safety notices at "Safety
80
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual
and power cords.
information" on page 129.
and power cords.
the 6216" on page 45 and "Removing the frame-support bracket" on page 45).
then push in until the fan is released. Pull the fan out of the computer.
information" on page 129.
Release
latch
Retainer slots