Service Processor Checkpoints - IBM 265 Service Manual

Service Processor Checkpoints

Service processor checkpoints are in the range E010 to E0FF. The message OK
indicates successful service processor testing and initialization. Firmware checkpoints
are listed in "Firmware Checkpoints" on page 88.
If you replace FRUs or perform an action, and the problem is still unresolved, go to
"MAP 1540: Minimum Configuration" on page 59 unless otherwise indicated in the
tables.
If you replace FRUs or perform an action, and the problem is corrected, go to "MAP
0410: Repair Checkout" in the RS/6000 Eserver pSeries Diagnostic Information for
Multiple Bus Systems .
Table 1. Service Processor Checkpoints.
Checkpoint
DIAG STBY
E000
E010
E011
E012
E020
E021
E022
82
Service Guide
Description
Service processor is ready. The system
unit was shut down in service mode by
the operating system; however, the
system unit is still powered on.
System support controller begins
operation. This is an informational
checkpoint.
Starting service processor self-tests
Service processor self-tests completed
successfully
Begin to set up service processor helps
Configuring CMOS
Configuring NVRAM
Accessing system board VPD
Action/ Possible Failing FRU
The service processor is ready. The
operating system has been terminated;
the system is still powered on. This
usually indicates an operating system
crash. The service processor menus are
available. Look for error codes related
to the operating system crash in the
service processor error log.
Call support.
Replace the system board.
Location: P1
(See note 3 on page 109.)
Call support.
Replace the system board.
Location: P1
(See note 3 on page 109.)
Replace the system board.
Location: P1
(See note 3 on page 109.)
1. Manually drain the NVRAM by
removing the battery. Short circuit
the battery leads for at least 30
seconds. Use a conductive object
such as a coin or a screwdriver for
this purpose.
2. Replace the system board.
Location: P1
(See note 3 on page 109.)
Replace the system board.
Location: P1
(See note 3 on page 109.)